Triumph TR6 engine rebuild

I've been putting some time in on the Triumph TR6 job and today it fired up for the first time. The engine was found to be in pretty poor condition, a lot of it had never been apart before. I had the crankshaft gound and block bored out and it's got new bearings, pistons, valves, guides, springs, timing gears & chain and various smaller parts. The owner got a set of refurbished throttle bodies from Fred Millturn, they were shipped ready assembled and engine tested so all I had to do was bolt them one and hook them up. They also supplied an excellent choke modification and all new throttle brackets, everything of the highest quality. I finished the assembly a couple of weeks ago and finished off the fitting, and fixing whatever else it needed, last week. Today it was just a matter of fitting the plugs and wires, filling the sump and cooling system, and firing it up, which it did once the air was out of the fuel injection system. A test drive and a check of the fluid levels and it should be good to go.